MY FEEDLY

1961 Mercedes-Benz O321H Camper Bus – Vintage Vanlife Royalty

This is a surprisingly well-preserved 1961 Mercedes-Benz O321H bus that was previously owned by the Swiss hockey team EHC Biel in the 1960s and 1970s.

The bus proved to be a good luck charm for EHC Biel who had started out as a second-tier National League hockey team, within a few years they were promoted to first-tier status and not long after this they went on to win three National League championships.

The bus was later sold into private ownership, and it was then converted into an RV capable of comfortably carrying a family on extended trips. This camper configuration includes two beds, two couches, a kitchenette with a sink, a stove, refrigerator, closets, a sunroof, seating for six people and a small bathroom with a sink and a porta-potty.

Ideally for use in Switzerland the bus came from the factory with expansive Alpine windows in the roof, perfect for gazing up at mountain peaks.

The Mercedes-Benz O321H Bus

When it was first released in 1954 the Mercedes-Benz O321H Bus represented a major shift in design for busses, particularly when compared to trucks.

Rather than using traditional body-on-chassis construction like trucks, the O321H Bus used a semi-monocoque design that both increased body rigidity and reduced weight.

Above Image: The bus has an adjustable driver’s seat, a driver’s door, and visibility is excellent due the large windows.

The design proved remarkably popular and over 30,000 examples were built during the 1954 to 1970 production run. Another perk of the semi-monocoque design was that it allowed far more room for luggage under the floor, making the busses perfect for cross-country or even cross-continent journeys.

The most common engine was the 5.1 litre diesel Mercedes-Benz 6-cylinder OHV unit, this naturally-aspirated engine proved incredibly reliable and it produced 110 bhp and 220 lb ft of torque.

Power was sent to the rear wheels via a fully-synchronized 5-speed transmission, and depending on final gearing the bus could achieve fuel consumption figures of between 15.2 and 16 litres per 100 kilometers.

The Mercedes-Benz O321H Camper Bus Shown Here

The unusual camper conversion that’s been applied to this Mercedes-Benz O321H makes it perfect for use either for road trip holidays or as a full-time home for someone who likes the vanlife ethos but needs a little more personal space.

The bus was bought from Switzerland to the United States approximately eight years ago, upon arrival it was given a fresh servicing by Mercedes-Benz specialist Ed Owen’s European Auto Solutions in order to ensure it was ready for whatever journeys the new owner wished to undertake.

Above Image: Inside the bus there’s seating for seven including the driver, and there is a double bed as well as two singles that can convert into a double bed.

After this it was displayed at the German Car Day at the Larz Anderson Auto Museum where it proved a surprise favorite, gathering crowds of curious onlookers and winning the coveted People’s Choice award.

The bus is now for sale via Fox Motorsports based in Grand Rapids, Michigan. In recent years its received some additional servicing including an oil/filter change, new diesel primer pump, fuel filter, six new tires, two new batteries, and a new ignition switch.

The bus also benefits from a recent full brake inspection including the reconditioning of the rear brake shoes, differential fluid change, brake fluid change, and front brake adjustment.

The current asking price is $94,900 USD, if you’d like to read more about it you can click here to visit the listing.

Images courtesy of Fox Motorsports

The post 1961 Mercedes-Benz O321H Camper Bus – Vintage Vanlife Royalty appeared first on Silodrome.

from Silodrome https://silodrome.com/mercedes-benz-o321h-bus/
via gqrds

Limited100 Automotive Prints – 100% Made In Britain

Limited100 was founded in 2020 by Simon Wright with a single purpose in mind, to create an entirely unique series of automotive prints that are 100% made in Britain – from the initial photography through to post-production, printing, packaging, and shipping.

Simon started the company after trying and failing to find automotive wall prints he wanted on his own walls, so he set to work finding photographers and printing companies who are based in Britain.

Each series of prints is limited to 100 units – hence the company’s name. Each is individually numbered and signed by hand, and the production of each print typically begins the day it is ordered.

When ordering you can choose between A1, A2, and A3 sizing. Unusually you can also choose to have your print on fine art paper, canvas, or on aluminum composite. Pricing starts at £119 and climbs from there to £189 and £269 for the larger sizes.

Above Image: Each print is limited to 100 units and they can be ordered in three sizes on a choice of fine art paper, canvas, or aluminum composite.

Limited100 uses only environmentally friendly water-based paints, and they explain that they finely tune the printing equipment to get the best most vibrant and accurate colour depiction.

Prints can be ordered already framed to save time, with either a natural wood frame, or your choice of either a black or white wood frame.

At the time of writing Limited100 has created collections with four highly-regarded automotive photographers including Paul Ward, Rick Noël, João Meneses, and Niall Julian with each collection including between eight and 30+ unique prints.

We’ve included a small collection of prints currently being offered by Limited100 here in this article, however there are dozens more on their website available for order.

The store page for each print includes a bio on the photographer as well as a detailed specification sheet for the car that was photographed.

Visit The Store

Images courtesy of Limited100. Photography by Paul Ward, Rick Noël, João Meneses, and Niall Julian.

The post Limited100 Automotive Prints – 100% Made In Britain appeared first on Silodrome.

from Silodrome https://silodrome.com/limited100-automotive-prints/
via gqrds

The Brütsch Rollera Microcar – A Rare Little Speed Demon Allegedly Capable Of 105 KM/H

Believe it or not, the Brütsch Rollera microcar was the large choice in its model family, it was based on the smaller Brütsch Mopetta. Both shared similar styling but the Rollera offered notably more space, and it had a more powerful motor.

Brütsch was a German car designer and automaker based in Stuttgart, the company had been founded by Egon Brütsch to design and build microcars, which in the post-WW2 period were exceedingly popular across Europe.

Perhaps the main reason for the popularity of microcars was the fact that they were cheap to build, cheap to buy, cheap to maintain, and miserly on gasoline. Europe was in a period of stringent austerity, but people still needed transportation.

The most famous microcar is probably the Iso Isetta, also produced under license by a number of other manufacturers including BMW. It would be this practice of having other people license his designs that would most appeal to Egon Brütsch. Although his company was an automaker he always seemed largely focused on the engineering and design of the cars, which he then hoped to license to other manufacturers for the more dreary job of actually mass-producing and selling them.

Above Image: This Rollera is fitted with an Isard 124cc two-stroke single-cylinder engine producing 6 hp.

The Brütsch Mopetta and the Brütsch Rollera

The Brütsch Rollera and Brütsch Mopetta both first appeared in 1956, the Mopetta was the “moped” version as it was fitted with a single-cylinder 49cc moped engine mated to a three-speed gearbox.

The Rollera was fitted with a larger 98cc Fichtel & Sachs engine with a similar three-speed gearbox, the body of the Rollera was slightly larger and there was more room internally.

The top speed of the Brütsch Rollera is said to be 105 km/h (65 mph) making it a bit of a speed demon in comparison to other microcars of the era – although it would be somewhat of an invigorating experience to travel at that sort of speed in such a small vehicle.

The Rollera was fitted with a perspex windscreen and a simple folding top to keep the rain off, however there were no side windows. The two models were offered until 1958 and although they were both licensed it’s believed that only the Rollera was actually built and sold, and even then it was in very low numbers.

Above Image: The cockpit of the Rollera was cozy and relatively simple. Steering was accomplished with handlebars and there was just a single gauge – a speedometer.

It’s typically very difficult to find Rolleras or Mopettas nowadays, so much so that a number of replica Mopettas have been built over the years. When they do come up for sale they typically attract plenty of attention and prices you may not expect, with some fetching over $60,000 USD.

The Brütsch Rollera Shown Here

The car you see here is a Brütsch Rollera from 1958, it was found in parts by its current owner who restored it carefully back to original specification – a demanding task given the extreme scarcity of spare parts.

This is one of the Rolleras that was built under license in France, so it’s fitted with a larger Isard 124cc two-stroke single-cylinder engine producing 6 hp. During the restoration no stone was left unturned, the chassis was restored, followed by the fiberglass body, and the engine was inspected and reassembled.

The vehicle is now likely one of the nicest Rolleras extant and it’s due to roll across the auction block with Artcurial on the 5th of February.

The price estimate is €30,000 to €50,000 and you can click here if you’d like to read more about it or register to bid.

Images courtesy of Artcurial

The post The Brütsch Rollera Microcar – A Rare Little Speed Demon Allegedly Capable Of 105 KM/H appeared first on Silodrome.

from Silodrome https://silodrome.com/brutsch-rollera-microcar/
via gqrds

The Extraordinary Art of Manu Campa

Over the past 10 years Manu Campa has risen to prominence as one of the world’s foremost automotive artists. He’s based in Malasaña, Madrid and he’s had exhibitions in Miami, Tokyo, New York, Lisbon, Biarritz, Oxford and Madrid before everything drew to a screeching halt because of the Covid-19 pandemic.

Although classic cars have always been a personal passion for Manu he didn’t start out as an automotive artist. After graduating with a degree in Fine Arts in 2008 from the Complutense University of Madrid he was first attracted to paintings that focussed on the aesthetics of everyday life.

Over time this developed into a passion for painting animals, then bicycles, and finally vintage cars. He enjoyed strong demand for his work at each stage due to his eye-catching style, his works now adorn walls in 35 countries and counting, and he’s collaborated with several A-list brands including Mini, Porsche, Kia, Coca-Cola, and Dunlop.

Above Image: The incredible photorealism of Manu’s work has won him accolades around the world and sales in 35+ countries.

He uses a photorealistic-style in his work, to the point that many people are convinced they’re looking at a photograph until much closer inspection. Many of his paintings focus on the famous design elements of iconic cars, like the D-Type’s fin, the Countach’s rear wing, or the much-lauded font end of the Miura.

Manu doesn’t just paint classic cars, he lives them too. His daily driver in Spain for many years was an original VW Beetle which recently made way for a 1931 Model A Ford – there aren’t many people in the world who use Great Depression-era cars as their daily drivers.

There are currently a dozen or so works listed in his online store for sale, and he takes commissions from people who would like to see their car (or the car of their choice) transformed into his inimitable style. If you’d like to see more of his work you can click the red button below, you can also click here to follow him on Instagram and be the first to see his new creations.

Visit The Store

The post The Extraordinary Art of Manu Campa appeared first on Silodrome.

from Silodrome https://silodrome.com/art-manu-campa/
via gqrds

Japanese Engineer Perfectly Re-Created Models From the Popular ’80s Sci-Fi Saga for His Son

In the 1980s, Japanese artist and sculptor Kow Yokoyama created Maschinen Krieger. This is a science fiction universe that involved building war machines that would fight in the 29th century. Back then, Maschinen Krieger took his visual ideas from the early NASA space program and early 19th-century weaponry. All models used for the war machines’ development were pieced together using numerous kits, including aircraft, armor, motor vehicle, as well as found objects.

Recently, a Japanese engineer was able to recreate models of the space war engines for his son. Basing his works on the eighties series of awesome model kits from Nitto Japan #SF3D, the Japanese engineer created the machines for his child as a way of reliving memories of the Maschinen Krieger series. The kid is also dressed as one of the figures from the kits while holding the design models.

The Maschinen Krieger Story

Maschinen Krieger tells a story about a war fought on Earth and the Moon in the late 29th century. A nuclear WWIV rendered the Earth uninhabitable in 2807. However, the earth’s environment restored itself miraculously by 2859. This allowed colonists to return to earth to rebuild.

With this going on, the Galactic Federation sends the Strahl Democratic Republic (SDR) forces to take control of the earth and form a ruling government. The war machines were developed to help earth inhabitants fight back and resist being colonized. This will involve a brutal and murderous battle that will be fought with the help of the machines.

Other Companies Producing the Model Kits

Apart from the Japanese engineer who built the model kit for his son, there are some other companies developing the kids. These include Rainbow-Egg, Love Love Garden, Modelkasten, Futch, Brick Works, and the renowned Silicon Tribe. Although, the older, full vehicle resin kits are still available. However, the prices of these model kids are exorbitant.